LCR Series Linear Rotary Actuators

Linear Rotary Actuators Lcr Series

The LCR series is the first linear rotary versions of the LCA series. The actuator is available with direct drive brushless servo motor. It's designed with linear guide built-in lubrication to offer long life cycle. Programmable force and "Soft-Land" capabilities. Absolute control over: force/torque, position, acceleration and velocity.

  • Soft-Land
  • MTBF 100 million life cycle
  • Vacuum through shaft prevents dust accumulation
Actuator Models Single Axis Controller Dual Axis Controller Amplifier Smart Driver
  LAC-1 LCC-10(11) LAC-26 LAC-25 LAA-5 LAD-1
LCR13/LCR16/LCR20 - MAH-RED226-03
(with 2x LCC-10)
MAH-RTD226-03 - - -

No cable required for flying lead option.

Linear encoder resolutions: 5µm standard, 1µm and 0.1µm optional for most units. Consult factory for availability.

Shaft ends: Male, Female, Blank and Custom (check availability of custom option)

Return spring: Prevents the shaft from dropping during vertical operation when power is cut.

Vacuum: For pick and place applications

Extended nose bushing: For tighter shaft run-out and higher side load onto the shaft.

Increase of max. force and acceleration: 48 volt coil and double coil options are available for some units with 24 volt single coil.

Increase of torque/gear ratio: Alternative geared motors are available. Please consult factory.

Rotary encoder resolution: Consult factory for higher resolution.

SMAC sites use cookies and similar technologies. By using SMAC sites, you are agreeing to our revised Privacy Policy and Terms of Service, including our Cookie Policy. I Agree

©2020 SMAC Corporation | 5807 Van Allen Way | Carlsbad, California 92008
Tel: 760-929-7575 | Fax 760-929-7588

Site Credits: Ecreativeworks

Ask a Question

*Your Name:



*Postal Code

Please Answer the Following Question:
What is 2+2