LAC-25 Dual axis controller

LAC-25 Dual axis controller

High speed dual axis controller with built in amplifier.

  • Two axis controller
  • Built-in amplifier
  • Single phase brush motor
  • Mode: Position Velocity Force Gearing
  • 12-48 VDC
  • 3amp, con. per axis, 6amp peak per axis
  • Independent or coordinated 2 axis motion
  • 4 opto-isolated input/output
  • 1 analog output/axis
  • RS232 interface
Stand-Alone 2 Axis Servo Motor Controller / Driver
Operating Modes
Position, Velocity, Torque and Electronic Gearing
Filter Algorithm
Max. Filter Update Rate
100 µS Per Enabled Axis
Trajectory Generator
Trapezoidal, Electronic Gearing
Servo Position Feedback
Incremental Encoder with Index
Output (Standard)
PWM Motor Drive, 3 Amps Cont. and 6 Amps Peak at 50 VDC Max.
PWM Frequency
Approximately 19.531 KHz
Encoder And Index Input
Single-ended or Differential
Encoder Supply Voltage
Encoder Input Voltage
5.5 VDC Max., -0.1 VDC Min.
Encoder Count Rate
2 Million Quadrature Counts per Second
Position Range
32 Bits
Velocity Range
31 Bits
Acceleration Range
31 Bits
General Purpose Digital I/O
4 Optoisolated Inputs, 4 Optoisolated Outputs
Dedicated Digital Inputs
Limit+, Limit-, Home and Fault for each axis
Analog Inputs
5 Channels With 10-Bit Resolution, 3 are user accessible
Analog Outputs
2 Channels With 12-Bit Resolution, ± 10VDC.
Communication Interface
RS-232 Serial Interface, Adjustable Baud Rate, 8 Bits, 1 Stop Bit, No Parity, XON/XOFF Handshake
Supply Voltage
+18 To +50 VDC
Motor Voltage
+12 To +48 VDC
Approximately 7.6“ Long by 3.3“ Wide by 1.1“ Thick
Approximately 1 Lb.

SMAC LAC-X Editor 1.01
Easy setup and tuning of control parameters for LAC-1, LAC-25, LAC-26, LAC-45 and Smart Driver.

©2019 SMAC Corporation | 5807 Van Allen Way | Carlsbad, California 92008
Tel: 760-929-7575 | Fax 760-929-7588

Site Credits: Ecreativeworks

(*) Required Fields
First Name: *
Last Name: *
Company: *
E-Mail Address: *
Phone: *
Country: *
Zip / Postal Code: *
Your Question: *

SMAC Cookies Policy