Product Range Controllers & Amplifiers

SMAC supply a variety of controllers and amplifiers to support their Actuators. The controllers allow code to be stored in non-volatile RAM which is then used to enable movements to be made in 3 different modes. These modes are desdribed in detail on the technical info page.
           
    LAC1
A single axis controller with 8 TTL I/O channels, 3 analogue I/P channels and RS232 interface.
 
           
LAC-1 High speed controller single axis c/w built in amp
     
LAC25
A dual axis controller with 4 opto isolated I/O channels, 2 analogue I/O channels and RS232 interface. The LAC25 can be used to control either a single Linear/Roatary actuator or alternatively two independant Linear actuators. It is also necessary for grippers.
   
LAC-25 As above but dual axis
     
LAA5
A stand alone single axis amplifier which can be used in conjunction with any propriertary controller. It provides +/-10Volt I/P, 3amp O/P.
LAA-5 Amplifier
     
LAD1
The LAD1 is used to convert stepper inputs to 3amp servo output. This is particularly useful wherever a SMAC unit is retrofitted to, or integrated into a stepper driven machine.
   
LAD-1 Smart Driver
 
MIO
E-8/8
  
If more I/O channels are required then the MIO can be linked to either the LAC1 and LAC25 to give 16 I/O channels.
Please note: This replaces the MIO16-R2
   
MIO E - 8/8 16 Channel I/O Expansion Module
** Terms of Service **
  • Due to SMAC's policy of continuing improvements we strongly recommend that all options are approved prior to ordering.
  • The above prices are offered only as a guide and we recommend that your local SMAC distributor is contacted for official quotation purposes.
  • All prices given are for 5 micron options.
  • We reserve the right to amend these prices to reflect any significant changes in the US$ / € exchange rates.
  • Prices are subject to a 5% charge to cover duty & carriage into the EU.
 
   
(c) copyright smac Inc. 2006